What are the working contents and precautions of the inner winding machine?

What is the safe operation of the winding machine?

1. Before starting the winding machine, carefully check whether there are sundries on the worktable of the winding machine, whether the screws on the winding machine are loose, whether the power switch is connected well, and whether the specifications of the enamelled wire meet the requirements. The machine can only be turned on if it is confirmed to be qualified, and the fault should be reported to the foreman or biotechnician for repair in time.

2. After starting the machine, run the empty car again, and pay attention to check whether the winding machine's arrangement, winding turns, reset mode and parking position meet the requirements. If it does not meet the requirements, you must repeat the above steps and readjust until the requirements are met.

3. When loose screws and abnormal sounds are found during operation, please press the emergency stop switch immediately and report to the foreman or biotechnician immediately for repair.

4. when the winding machine is running at high speed, it is forbidden to come into contact with the moving parts, to use the machine in strict accordance with the operating specifications of the winding machine, and to start the machine when hanging up the wire and loading and unloading the skeleton fixture.

5. Before getting off work, the operator should do a good job in the cleaning and maintenance of the equipment according to the requirements, do a good job in the cleanliness of the surrounding site, put the product parts neatly, and turn off the power supply.

Matters needing attention in safe operation of winding machine.

1. The operator must pay attention to safety. After the machine is started, the hand cannot be close to the rotating part. When adjustment is needed, the machine must be stopped first and then adjusted. After the adjustment is completed, it must be confirmed that the hand has left the dangerous area before restarting.

2. The operator should not wear gloves at work, the sleeves should not be too long, and the female foreman's hair should be tied up.

3. When there is an abnormal sound in the machine, the operator should stop the machine immediately and find the equipment maintenance personnel for overhaul. do not take the initiative, so as not to cause waste of materials and damage to the machine.