Why does the automatic winding machine make abnormal noise?

During the winding process, the automatic winding will hear a very subtle uh-huh sound, which is the normal sound of running around the wire; when the shaft slides, the scratches of the guide rail will be heard; and occasionally there will be the sound of gas released by the air pump. Generally speaking, it is pleasant and will not have a bad sound. Experienced people can judge whether the winding machine is abnormal by the sound of the process.

If the screw is not tightened or the part needs to install the screw but does not have the installation screw, the inertia impact of the winding machine part during operation may cause the part to loosen, and the impact may occur in severe cases. Therefore, when you hear the impact sound, you must block the machinery and quickly check the equipment; if the base of the winding machine is not heavy enough or the floor is not satisfied, the winding machine will shake and reach the sound during operation; there is not enough lubricating oil in the bearing. Hissing sound is heard in the bearing chamber; the steel ball in the bearing is damaged and there is a grunt in operation. Loose rotor parts, such as loose counterweight screws on cage rotor blades or loose rotor shafts, will make the winding machine knock; if the shaft bends or bearings wear, the winding machine will also vibrate and friction unevenly; wire lacquer wear leads to the intersection of two wires, there will be a noise, but it has already caused a short circuit and serious damage to electronic parts, so the usual inspection and maintenance is more important than maintenance.

What is explained above is the reason for the abnormal sound of the automatic winding machine. I hope it will be helpful to you after reading it. If you want to know more about the automatic winding machine, welcome to consult customer service online or call our service hotline (upper right corner of the website). We will try our best to provide you with intimate service!