Common faults of automatic Winding Machine

The fully automatic winding machine can wind all kinds of electromagnetic coils, which are usually around the electromagnetic coils and certain electromagnetic coils. In the setting, different solenoid coils will have some differences. Be sure to set the main parameters properly and adjust the supporting force and installation mode of the winding before winding stronger works of art and better-looking solenoid products. In addition, the automatic winding machine may encounter a variety of problems in the whole operation process, and the most common key conditions are the following.

The winding of solenoid is not normal. When this occurs, it is necessary to analyze whether the problem arises during normal settlement or after the disassembly and adjustment of the commodity. In the case of the former, it is mostly due to hardware configuration challenges, while in the case of the latter, it is usually a setup problem. The hardware configuration problems may be caused by the loose fixture tools, the loose fastening screws of the wiring mechanism and the lack of wet natural environment of the wiring mechanism, resulting in common wiring failures of the servo motor when running under load.

The parts of the spindle bearing block are not accurate, which is also a common situation of the automatic winding machine. This situation is mainly caused by the difficult problems of the braking system. Such as brake pad loose, or gray-black brake pad wear. In addition, it has a lot to do with the setting of braking system time. If the setting time is not enough, it will lead to positioning error of the spindle bearing. To solve this problem, the brake pad must be removed or the brake system must be readjusted.

The electromagnetic coil of the winding wire is not accurate, or the total error of the winding machine is mainly due to the difficult problem of the inductor or control board, which makes the winding machine can not work normally. Therefore, it is necessary for the manufacturer of the automatic winding machine to maintain it. Abnormal sound will appear in the whole operation process of the automatic winding machine, and the difference of noise can be used to distinguish whether the winding machine has abnormal problems or not. Of course, this must be identified by technical professionals.

What is explained above is the common failure of the automatic winding machine. I hope it will be helpful to you after watching it. If you want to know more about the automatic winding machine, welcome to consult the customer service online or call our service hotline (upper right corner of the website). We will try our best to provide you with quality service!