Various functions of automatic Winding Machine

The automatic winding machine can complete the automatic winding, and calculate the release length and operation flow according to the frame specifications and winding requirements. After that, the push data signal is designed according to the single-chip microcomputer to complete the rotation manipulation of the servo motor and the main motor. For the servo motor with professional Optocoupler circuit to form the zero wire hot line of the stepper motor, the main AC motor can use a communication AC soft starter to adjust the control port number in the soft starter after setting the operating rate, and then decide to stop, open, click, and so on. In order to make the winding machine complete the winding, communicate with the AC main motor and servo motor to apply the manipulation data signal.

The winding parameters are input by keyboard, and the information is displayed in the liquid crystal display module to reduce the total number of function keys. The liquid crystal display control module provides a large display information volume and identifier picture library. In the case of wire winding, it is stipulated that the immediate display information of the number of turns at the present stage should be displayed, the metering verification of the rotating turn of the main motor should be carried out, and the number of electromagnetic coils around the main motor can be obtained by taking into account the transmission ratio of the main motor. and the winding will be terminated when the number of turns is the same as the total number of turns set in advance, and optical inspection is applied here. The turn stage can quickly terminate the main motor in the case of checking the number of turns and expecting the total number of turns in advance. here, using the optical inspection stage, the single-chip microcomputer design also needs to expand the program flow of EPROM storage automatic actual operation winder.

The initial winding mechanism is mainly composed of synchronous belt, motor, upper and lower fixture, supporting rod and clamping bullet yellow. The upper and lower fixtures are coaxial output weapons and equipment, and the left fixture uses the shaft to connect the synchronous belt to push the pulley to carry out the positive winding posture according to the drive of the motor. The right fixture is provided with a concave groove on the right, in which there is also a rolling bearing, the outside of the rolling bearing and the fixture cooperate with each other, the inner hole and the supporting rod are transitional, and the supporting rod is installed in a fixed guiding block. The right fixture is installed in the right fixture and the guiding block support rod, so after the upper and lower fixture clamps the empty inductor, the right fixture will carry out the driven rotation around the rolling bearing when the left fixture rotates, which can promote the rotation and winding of the barrel.

What is explained above is the various functions of the automatic winding machine. I hope it will be helpful to you after reading it. If you want to know more about the automatic winding machine, you are welcome to consult the customer service online or call our service hotline (upper right corner of the website). We will try our best to provide you with quality service!