Is the operation of transformer coil automatic winding machine important?

The general common functions are lap preset, automatic parking, forward and reverse winding, automatic slot crossing, etc. In practical use, we should pay attention to several points, first of all, starting and winding the slow car and stopping the slow car, the function of starting and winding the slow car is to run slowly after the equipment is started. in order to reduce the impact on the tension structure and enamelled wire, 1 to 3 laps can be set according to actual needs. The slow parking function is that the equipment runs slowly before the end of the winding sequence, which can reduce the impact on the brakes and make the equipment end the winding smoothly, especially the winding process that requires accurate positioning. This parameter must be set. According to the running speed of the equipment, the parameters should be adjusted to 2 to 5 laps, followed by the direction of arrangement and winding. These two parameters are the setting of the displacement direction of the line and the rotation direction of the spindle.

1, the connection of the winding machine: after knotting the new thread with the old thread before running out of online, manually pull to the guide needle and then start.

2. In the automatic working state, the body of the personnel shall not be put into the area between the skeleton material trough and the feeding tooling, otherwise the danger of clamping will occur.

3. The path of the line confirms the porcelain eye before starting the machine, and the flywheel of the tensioner must cross the line once. It is easy to manually clamp the wire by turning on the unloading switch, which must be turned off before turning on, otherwise the clamp will not be secure.

4. In the event of a power outage or emergency stop, please reset and re-clamp the wire and restart.

5. Please make sure that the electricity and compressed air are in place and reset manually before starting. In the operation of transformer coil automatic winding machine, the operator needs to pay attention to the operation, as long as pay attention to the above items, we can reduce the occurrence of faults, will not slow down the efficiency of production.