How is the stability of the external winding machine?

The use of external winding machines is related to the scope in the industry. After all, the times are changing now. Most products are processed by machinery and equipment, and the quality and effect of most products are guaranteed to a certain extent. This is why more and more processing manufacturers will introduce machinery. It is also the demand of the market. About the application of these external winding machines, let's understand its performance.

There must be good instrument grounding on the winding machine. It is worth explaining that the grounding electrode of the winding machine is different from the lightning protection grounding in civil engineering, the location of the grounding electrode should be three meters away from the control room, the vertical direct ground electrode of 20mm diameter galvanized angle steel should be used 1.5 meters under the outdoor floor, the grounding resistance should be less than 1 ohms (shaking meter test should be used when backfilling), and then reliable welding of 40X40X4 galvanized flat steel and grounding body (careful anti-rust treatment should be done for each welding joint). Transfer the 25mm copper cable to the system terminal and the winding machine connection place in the building. This can effectively reduce the harm caused by static electricity.

Demagnetization caused by long-term overload of the motor caused by the damage of the supporting bearings at both ends of the screw or the damage of the ball screw or other physical faults. Other faults of stepper motor. Other failures with the stepper drive. The sampling device for the position of the cable rack is damaged or unstable. The instability of the control system. The spindle runs or counts abnormally. First of all, turn the spindle by hand to feel there is no force point, in order to eliminate physical problems. Remove other shafts to reduce the load after the test machine, if possible, you can replace the same type of motor test. There is a failure in the motor drive. Control system failure. The spindle positioning counting circuit board is damaged. The servo motor 5V enable circuit is abnormal. The screen is abnormal. Replace the monitor or monitor connection cable. Change the main program chip.

Measure the screen power supply voltage. If there is a source of interference around. Spindle runout or noise. Check bearing lubrication. Shake the bearing and check the position of the bearing gland. Remove the motor to observe whether the synchronous belt is worn. The power supply system is unstable, the power supply voltage fluctuates greatly, it is easy to blackout, the rapid development of industry and life, the demand for electricity is also increasing day by day, many areas have insufficient power supply, voltage instability, easy power outage occurs from time to time. Voltage instability and sudden power outages cause the system to restart frequently, and electronic components may be damaged due to the impact of current, so the stability of the power supply in the working environment is related to the normal operation of the winding machine, and the stabilized power supply and UPS uninterruptible power supply can be used to protect it.